|
|
Post by fullchiselantique on Dec 23, 2019 21:10:31 GMT -5
scrounged up an xl 903 needs work and sadly a piston and cylinder because it looks like someone dropped a bolt inside I located a decent cylinder but will an xl925 piston work for a replacement. I can't find a 903 piston. unless someone here has one sitting around that they would be willing to part with. This old girl has been pretty neglected but one of the 900 series saws has been on my want list for a while. Also buddy laughed at me and said i'd never make it run so i have the make him eat his words incentive going on also 
|
|
|
|
Post by Clasec on Dec 23, 2019 21:21:45 GMT -5
Welcome to House of Homelite. If the replacement cylinder is 2 1/16 inch bore then a 925 thick ring piston would work okay.
|
|
|
|
Post by fullchiselantique on Dec 23, 2019 21:27:27 GMT -5
I see new ones available for the xl925 from lil red barn would these be thick or thin ring? part # A6946.
|
|
|
|
Post by Clasec on Dec 23, 2019 21:29:35 GMT -5
I see new ones available for the xl925 from lil red barn would these be thick or thin ring? part # A6946.
The ones from LRB would be thick ring. Thick ring on left thin on right.  xl923 Cyls 923-925 pistons by Clasec, on Flickr |
|
|
|
Post by scotts2000 on Dec 23, 2019 21:30:29 GMT -5
Dependent on bore I have the 68033 piston
|
|
|
|
Post by fullchiselantique on Dec 23, 2019 21:41:26 GMT -5
waiting for the new cylinder to arrive pretty sure it's 2 1/16 but i'll measure when it gets here to make sure. Thanks for the welcome. Hope this old girl will breathe fire again I have a model 17 and a couple sxl's that need some company
|
|
