|
Post by oologahan on Dec 14, 2019 22:12:44 GMT -5
I like to have spare parts on hand so I collected a bunch of NOS and OEM parts. I have a set of rings for almost 50 saws, as well as the gas cap and oil cap gaskets for most of my saws. I also have about 25 sets of oil seals, and 10 NOS mufflers as well as a few coils and modules. I ordered 12 sets of decals from Joe so I would be ready when I needed them. I was happy to find a NOS EZ-250 clutch cover as well as several XL-100 covers and an early XL-800 cover that used 5/16" studs along with two XL900 covers. I also acquired several other SXL covers and a XL-400 and SXL starters I found some good used and older NOS XL-700-900 starters. I traded a Homelite bar for a SEZAO full wrap handle. I think I have 25 NOS sprockets for SEZAO, XL-100, SXL, and XL-900 saws, with about 6-7 eight tooth sprockets. I got a great deal on a couple dozen races and hub bearings as well. I bought a lot of Homelite Filters that gave me a couple replacements for most of my saws (55?) and have large bag of fuel filters that came with several sets of rubber grips.
|
|
|
Post by onlyhomelites on Dec 14, 2019 22:24:13 GMT -5
Nice stash of parts!
|
|
|
Post by Clasec on Dec 14, 2019 22:48:06 GMT -5
|
|
|
Post by ettrick on Dec 15, 2019 9:22:09 GMT -5
Wish i had more parts on hand, but then i have storage problems and could not find them when i need them. Dan
|
|
|
Post by oologahan on Dec 15, 2019 16:10:38 GMT -5
Wish i had more parts on hand, but then i have storage problems and could not find them when i need them. Dan I box them all up in one large box and have smaller boxes inside that I separate parts by saw family. On the outside of the large box I have all the parts inside listed. I'm going to do something similar with smaller internal parts as well in a parts drawer
|
|