360 starter parts

[Brennan]

So here’s the story, I went to pick up a blue xl-12 today and happened to spot a 360 hiding in the corner looking very sad so naturally I asked about it. I was told it was seized and that the starter was broken so I got the saw for 10 bucks. Got it home and looked a little closer and noticed that the pull cord had snapped and all the extra peices of the starter had vanished. Low and behold where the rope snapped it jammed it making it seem like it was seized. After installing a new cord I dumped some fuel down the carb and it fired right off. However right now it has the rare “manual rewind” option that I done much care for.
I’m working from this ipl: www.leonschainsawpartsandrepair.com/uploads/3/9/7/9/39792537/homelite_360_chainsaw_ipl_17080.pdf

I think I need parts number 24, 25, 26, 28, and 29. I can get everything except the recoil spring from Leon and was hoping to find one for a better price than feebay. I’ll post some pictures of what pieces I’ve got tomorrow afternoon but for now here’s the ut and serial number

[Brennan]

Here’s the pictures of the saw, has a 360 professional clutch cover but seems to be missing the inlay on the starter side



The saw needs more work than though it did, the intake boot has gone south
Here’s what’s left of it


Intake boot putty anybody?

[edju1958]

t kinda looks the same as the boot I took out of my 360.I just pulled another 360 apart & the boot was good,but whoever worked on it previously used Tygon on everything including the impulse line.The fuel line needs to be replaced because they must've been using ethanol gas & the line was brittle.

                                                             Ed