|
Post by edju1958 on Jul 10, 2019 17:45:40 GMT -5
I just picked up another SEZ on Ebay for $45.UT# 10505-B,Serial # 2G1610171.I went through the saw when I got it earlier today & it looked to be in good shape.I fueled it up & within a fewe pulls it wanted to start,but it seems that the idle was too low.I turned the idle screw in all the way & it still wouldn't idle.I set the hi & lo needles at one turn out from seating & it had the same problem.I turned the lo & hi in 1/4 turn each so they're at 3/4 turn out from seating & the saw idles & throttles up nicely,but when I shut the saw off & try to restart it it won't start unless I have my finger on the throttle trigger.I know there's a screw on the front of the throttle trigger assembly that's supposed to be used to set the saw for starting,but I don't know what that's supposed to be set at. Ed
|
|
|
Post by undee70ss on Jul 10, 2019 18:53:28 GMT -5
|
|
|
Post by edju1958 on Jul 10, 2019 19:24:55 GMT -5
Thanks Greg,this should be VERY helpful! Ed
|
|
|
Post by rowdy235 on Jul 10, 2019 20:27:57 GMT -5
Can't say it any better than that My SEZ is a little temperamental with starting warm, may need to make some adjustments.
|
|
|
Post by undee70ss on Jul 10, 2019 22:48:26 GMT -5
Can't say it any better than that My SEZ is a little temperamental with starting warm, may need to make some adjustments. Richen the low mixture some, to lean of a Iow mixture will cause hard starting when warm.
|
|