Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 22, 2018 19:42:51 GMT -5
|
|
|
|
Post by sweepleader on Apr 22, 2018 20:14:28 GMT -5
Stickers on the packages say they will. Anyone else got ideas on this?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 22, 2018 20:38:28 GMT -5
Stickers on the packages say they will. Anyone else got ideas on this? It looked like many of these bars only have one oil hole. Is that normal, can you flip these bars? |
|
|
|
Post by Clasec on Apr 22, 2018 20:56:58 GMT -5
Stickers on the packages say they will. Anyone else got ideas on this? It looked like many of these bars only have one oil hole. Is that normal, can you flip these bars? Probably only drilled on one side so you can't see the other hole unless you turn it over. That's my guess. |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 22, 2018 21:07:35 GMT -5
It looked like many of these bars only have one oil hole. Is that normal, can you flip these bars? Probably only drilled on one side so you can't see the other hole unless you turn it over. That's my guess. Gosh the brain fog has gotten so thick, I don't think I should operate a saw, sure hope I get some relief soon. |
|
|
|
Post by sweepleader on Apr 23, 2018 7:02:42 GMT -5
Sounds like you need a new saw!
|
|
|
|
Post by onlyhomelites on Apr 23, 2018 8:13:46 GMT -5
Sure-fire cure!
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 23, 2018 10:11:11 GMT -5
Sounds like you need a new saw! I am getting a new saw, BrianVT is sending me a SEZAO, I'm going to stick with the Oregon 24 inch bar and LPX chain, I thinks that's plenty for my Super XL-925 and its quality stuff. I can get the combo for 87.00 shipped |
|
|
|
Post by kysawman on Apr 23, 2018 10:36:00 GMT -5
I have used some of the Archer bars for smaller Husqvarna saws, they stand up reasonably well. I have NOS Winsor/sandvik and GB 20" hard nose for the large mount if you need any. I got 40 dollars in them.
|
|
|
|
Post by kysawman on Apr 23, 2018 21:08:36 GMT -5
The D176 mount bars have a very similar tail profile but have 5/16 bar slot instead of the 3/8 need for the later homelite saws. They work great for use on the old xl-12 super xl thigh the smaller stud . I have milled the D176 out to fit 3/8 studs with very little trouble ( got a good buy a a flee market).
|
|
|
|
Post by rarefish383 on Apr 26, 2018 6:17:15 GMT -5
I put an Oregon 30" bar on my XL924. I was using it to mill some smallish Poplar logs, and the whole bar isn't buried. I think they were about 20" logs. I also like to have the tip of the bar sticking out a little when bucking firewood. I usually use the FEL to put the logs on cross pieces to stay out of the dirt, but don't always. If I'm bucking 24" logs I like the 30" bar so I can see the far side better, Joe.
|
|
