|
Post by 99tahoe on Dec 21, 2017 10:00:26 GMT -5
Hello well I picked up a part saw for my 101 with the glued tank this one is a screwed toghter tank but low and behold theres a hole in the tank now I was thinking about separating the two section of the tank and patching it from the inside my question is how hard is it to pull them apart and is there any special step that I should do etc also do I need to pull the crank out or will the pieces come apart around it thanks
|
|
|
Post by onlyhomelites on Dec 21, 2017 15:08:16 GMT -5
It looks like you should be able to separate the tank without removing the crank...let us know how it goes.
|
|
|
Post by 99tahoe on Dec 21, 2017 16:31:24 GMT -5
hello did a little digging into it and I did not see a screw had to take out the rubber damper around the clutch and it comes apart with out removing the crank now I just have to get a broken screw from the tank out ....should be fun
|
|
|
Post by sweepleader on Dec 21, 2017 17:04:47 GMT -5
Moved this to XL-101
|
|