|
Post by strtjoints on Nov 14, 2017 17:29:25 GMT -5
HI; WHAT IS CORRECT AIR GAP SETTING FOR 360 ? BETWEEN COIL & FLYWHEEL?
|
|
|
Post by undee70ss on Nov 14, 2017 17:30:59 GMT -5
.010 - .012. A business card works in a pinch.
|
|
|
Post by strtjoints on Nov 14, 2017 17:34:31 GMT -5
.010 - .012. A business card works in a pinch. tHANKS SO MUCH
|
|
|
Post by strtjoints on Nov 14, 2017 18:31:02 GMT -5
i HAD GOOD SPARK FROM AT SPARK PLUG WITH TESTER RIGGED UP. AT .010 THEN NO SPARK . THEN SPARK AGAIN THEN NO SPARK. SO SPARK IS INTERMITTENT AS FAR AS i CAN TELL . HAVE REPLACED MODULE & CONTACT SET & TRANSFORMER. ANY IDEAS?
|
|
|
Post by stillsawing on Nov 14, 2017 18:53:27 GMT -5
Homelite mentioned in a service memo that the crimped ends on the leads between the module and the transformer be checked and or recrimped. Also said to disconnect the on-off switch, to isolate a possible defective switch. Good luck
|
|
|
Post by strtjoints on Nov 14, 2017 18:57:07 GMT -5
OK i WILL TRY THAT. tHANKS
|
|
|
Post by undee70ss on Nov 14, 2017 19:05:15 GMT -5
I had a 360 with a similar problem. Small cracks in the insulation was allowing a short to ground from module. I would also re insulat the wires ( I used shrink wrap tubeing)
|
|