|
Post by dave123 on Dec 8, 2014 17:01:10 GMT -5
Looking for rings for a 'Homelite 410' 49mm thin, have spent a couple of hours on the net searching but no luck yet, looks like they are rare'er than hens teeth.
|
|
|
Post by dave123 on Jan 10, 2015 22:37:57 GMT -5
Don't need them now, have modified the piston to accept Stihl 039 rings.
|
|
|
Post by cblackky on Jan 11, 2015 7:00:29 GMT -5
thanks dav123 i will do that to the 410 i got are they hard to do a boot on thanks
|
|
|
Post by dave123 on Jan 11, 2015 19:41:21 GMT -5
To do the intake boot is easy, my saw was pulled apart to do this, not sure if it can be done without pulling it apart. Regarding the rings, I have a lathe and ground out the ring locating peg with a Dremel /cutoff wheel, dremel was mounted to tool post on lathe, then widened the ring groove to suit the Stihl ring. 410 ring is .024 (thin) and I think the Stihl ring is 1.25mm. No new locating peg was fitted. Good luck with yours.
|
|