|
Post by edju1958 on Jul 25, 2024 19:30:10 GMT -5
I picked up this XL-102 about 5-6 yrs.ago & misplaced it until a few weeks ago.The handle bracket was slightly broken so I got a new one & the mounting pads from Leon.The saw acted like it had bad crank seals,so I fired it up & sprayed brake cleaner where the seals are.If the seals are bad the saw will stall out in an instant & this didn't happen.I figured that the carb may have an issue so I pulled that out & went through it.I couldn't find a thing wrong in the carb,so I put it back in the saw.Then I had a problem getting the fuel line back onto the inlet elbow.I finally got the line back on the carb & now it'll only run on a prime.Anyone got any ideas?
|
|
|
Post by undee70ss on Jul 26, 2024 22:17:09 GMT -5
points or condenser?
|
|