Parts available for Homelite 360- UT# 105794 /SER# 502900026

[teamsturz]

Picked it up to tinker with and hopefully get running.  I replaced carb rubber boot and put a new sparkplug.  Tested spark and ignition and seemed to be working.  Compression was 85psi on 6 pulls, so I tore it down to find no rings left.  Never had a small engine tore down to this level, but did so to learn. I did find a broken oiler hose and the chain tightener was chipped off.  Don't know that I could reassemble if I wanted to.  I have no sentimental interest in this saw, so I hope to sell hard to find parts for others to fix theirs.  Any reasonable offers will be accepted, plus ACTUAL shipping cost to your address from Eau Claire, WI.  I'll operate on TRUST until I get screwed, but I hate to give Ebay a cut and avoid the hassle.  It's listed on Marketplace, but no local response as of yet.  C:\Users\teams\OneDrive\Pictures\360 saw.jpg

[teamsturz]

Jun 6, 2024 18:40:48 GMT -5 teamsturz said:

Picked it up to tinker with and hopefully get running.  I replaced carb rubber boot and put a new sparkplug.  Tested spark and ignition and seemed to be working.  Compression was 85psi on 6 pulls, so I tore it down to find no rings left.  Never had a small engine tore down to this level, but did so to learn. I did find a broken oiler hose and the chain tightener was chipped off.  Don't know that I could reassemble if I wanted to.  I have no sentimental interest in this saw, so I hope to sell hard to find parts for others to fix theirs.  Any reasonable offers will be accepted, plus ACTUAL shipping cost to your address from Eau Claire, WI.  I'll operate on TRUST until I get screwed, but I hate to give Ebay a cut and avoid the hassle.  It's listed on Marketplace, but no local response as of yet.