|
Post by ibmike on Feb 15, 2024 8:25:03 GMT -5
I started taking it apart, intake boot was like roof tar in a tube, fuel inlet on the carburetor is cracked plastic, fuel and impulse lines are in good condition but will replace, along with 4 new isolators. Will JB weld work on the inlet or can i remove and replace it ? problem i have never had to address before, once repaired i will do a carburetor kit. Mike
|
|
|
Post by onlyhomelites on Feb 15, 2024 8:58:55 GMT -5
I've never spent the time looking for a replacement elbow, Walbro doesn't list one in the carb IPL, but something must be out there. I just go the JB Weld route and it's always worked for me.
|
|
|
Post by ibmike on Feb 15, 2024 9:34:37 GMT -5
I've never spent the time looking for a replacement elbow, Walbro doesn't list one in the carb IPL, but something must be out there. I just go the JB Weld route and it's always worked for me. Thanks Leon, i'll go that route
|
|
|
Post by blythkd on Feb 15, 2024 12:13:21 GMT -5
I've done the JBW thing too and had success. I believe if you can find an all steel 50558 Homelite elbow, it will work too. It's been a while so I'm not 100% sure but I think it'll work.
|
|
|
Post by onlyhomelites on Feb 17, 2024 9:59:14 GMT -5
I believe if you can find an all steel 50558 Homelite elbow, it will work too. It's been a while so I'm not 100% sure but I think it'll work. I believe you are correct...the challenge is finding it!
|
|
|
Post by charles on Feb 17, 2024 13:06:32 GMT -5
A Walbro 128-152 should work and it's a metal piece .
Charles
EDIT : the carb stem measures 0.157" . i have used the 128-152 on both a SDC and Tillotson HS to replace
the "fat" fuel line stems on the earlier carbs .
The part shows available on line but my local saw shop was able to order it through his distributor . Took about a week to arrive .
|
|
|
Post by blythkd on Feb 17, 2024 15:35:57 GMT -5
Charles, I was finding Walbro 128-152-1 when I searched online. Is that the same thing? Thanks for the Walbro reference, I'm going to write it down in an IPL.
|
|
|
Post by ibmike on Feb 18, 2024 8:16:33 GMT -5
A Walbro 128-152 should work and it's a metal piece . Charles EDIT : the carb stem measures 0.157" . i have used the 128-152 on both a SDC and Tillotson HS to replace the "fat" fuel line stems on the earlier carbs . The part shows available on line but my local saw shop was able to order it through his distributor . Took about a week to arrive . Thanks Charles for the information, I have a box of old carburetor's and found a good plastic one to use
|
|
|
Post by charles on Feb 18, 2024 15:02:07 GMT -5
Charles, I was finding Walbro 128-152-1 when I searched online. Is that the same thing? Thanks for the Walbro reference, I'm going to write it down in an IPL. Sorry I missed your question about the part number . Yes , it's the same part , just a later number . Charles
|
|