|
Post by nimrod55 on Feb 5, 2023 18:29:31 GMT -5
I was putting the recoil cover back on after rebuilding it. The off switch wire had cone off the coil end. when I was putting it back on I noticed the coil is a bit loose on the core. This is not the core is loose on the back plate. The coil wiggles just a little bit. The saw runs fine. Is there some way to tighten this up? It looks like it could cause a problem if it got looser.
|
|
|
Post by onlyhomelites on Feb 5, 2023 20:00:21 GMT -5
There should be a retainer strap that is screwed to the lamination. You can remove that and the coil, bend the strap a bit and reinstall to tighten it up.
|
|