|
Post by ronaldt on Dec 4, 2022 16:53:30 GMT -5
I have a very nice original condition EZ-6. I've never done a thing to this saw because it has always ran extremely well. This spring it had a spell where it didn't want to idle down. I tinkered with the throttle linkage a bit and it seemed to be ok. I was going to take it to a gtg yesterday but it's doing the same thing again. Seems like it wants to run at like 1/3-1/2 throttle. The only way I can get it to idle down is to choke it partially. It's probably something simple but was hoping to get some opinions on where to start. The saw wind up great and has great power but won't idle down. Any thoughts?
|
|
|
Post by ronaldt on Dec 5, 2022 18:48:13 GMT -5
Never mind. I think I got it figured out... 😔
|
|
|
Post by undee70ss on Dec 5, 2022 20:16:07 GMT -5
Air leak?
|
|
|
Post by ronaldt on Dec 5, 2022 21:30:13 GMT -5
Almost out of fuel. How dumb is that...
|
|
|
Post by undee70ss on Dec 6, 2022 5:51:59 GMT -5
Almost out of fuel. How dumb is that... That’s simple
|
|