|
Post by undee70ss on Jul 21, 2022 22:22:45 GMT -5
i just noticed it says collector wanna be. lol funny and true It is based on you post count.
|
|
|
Post by 5terrysupersaws on Jul 21, 2022 23:30:18 GMT -5
Terry its not a super xl. its a xl 12 btw thanks for all the input. i want to get it running good and give it to my son since it has the best comp.out of the 3 i bought its funny. the red one has the lowest comp but runs really good. 120 comp No problem, the HS-96A was also used on the XL-12 as an alternate carb for the Walbro SDC-29. Are HI/LO mixture adjustments having any effect on the bogging-stalling condition ?
|
|
gman
Collector wannabe
Posts: 16
|
Post by gman on Jul 22, 2022 13:38:28 GMT -5
no change from highscrew unless i close it all the way then it wont rev low screw doesnt affect wot. but will cause it not to idle
|
|
gman
Collector wannabe
Posts: 16
|
Post by gman on Jul 22, 2022 13:39:38 GMT -5
i guess i will pop out welch plugs just to make sure nothing is gunked up in there
|
|
gman
Collector wannabe
Posts: 16
|
Post by gman on Jul 22, 2022 13:41:33 GMT -5
it will go a few seconds into cut then just stop sometimes it will stall out and sometimes just idle
|
|
gman
Collector wannabe
Posts: 16
|
Post by gman on Jul 22, 2022 13:44:36 GMT -5
what would be your next steps
|
|
gman
Collector wannabe
Posts: 16
|
Post by gman on Aug 17, 2022 10:39:25 GMT -5
update. i popped welch plugs. the smaller one on high speed needle side had a screen that was dirty. after i cleaned it. it is much better and will run without bogging on 3/4. throttle. but at full it still boggs
|
|
|
Post by papawfixit on Nov 8, 2022 13:34:53 GMT -5
update. i popped welch plugs. the smaller one on high speed needle side had a screen that was dirty. after i cleaned it. it is much better and will run without bogging on 3/4. throttle. but at full it still boggs Were you able to get the full throttle bog cleared up?
|
|