|
|
Post by riseandrun on Jun 20, 2022 18:45:44 GMT -5
My last thread was condenser help. Now I have no spark. I took the points out to follow my hanging wire and after I reinstalled them I I have no spark. ..015š¤. I rotated the piston to what I determined was TDC by looking and feeling the top of the piston and adjusted and tightened the plate. Am I missing something or āif at first you donāt succeedā¦ā. (The way my repairs usually happenā¦)
TIA
R&R
|
|
|
|
Post by bobby167 on Jun 21, 2022 7:10:13 GMT -5
Check flywheel key? Clean / file points & re-gap, .015. Make sure points are opening. Could be bad kill switch, un-hook wire & see if you have spark. Condenser could be bad or weak. Plug wire could be loose, where spark plug goes into it.
|
|
|
|
Post by riseandrun on Jun 21, 2022 13:51:14 GMT -5
Thanks Bobby. My method is correct? It would figure that it would just quit after taking points out, because it was sparking fine before I took the saw apart to trace the flywheel wire. Will report back when I get this simple saw runningā¦š
|
|
