|
Post by edju1958 on Mar 6, 2022 17:48:15 GMT -5
I've got a nice little Xl Automatic that has a broken handle cover.I can't find the ID tag on it anywhere.It's a late model XL,single trigger,with one screw in the front & one screw in the rear to hold the cover on.The saw runs great,but needs duck bills for the fuel & oil tanks.Another question I have - how do I get the fuel & oil tanks out of the saw?Normally I've had them practically fall out.
|
|
|
Post by bobby167 on Mar 6, 2022 19:52:05 GMT -5
Should be part # 02495. To remove fuel / oil tank you will have to remove the engine assembly. 2 screws on top & 2 screws on bottom. Will Have to take starter off , unhook wire from switch. Be careful with throttle linkage, the ends are different shaped bends. When you get oil tank out, check for metal fitting in oil line. This is where duckbill goes. If missing shake the tank to see if it is stuck on bottom of tank. undee70ss posted repair manual in this section, from Leon's site.
|
|
|
Post by edju1958 on Mar 6, 2022 20:20:15 GMT -5
I'm well aware of how to disassemble an XL,I've pulled Super 2s apart before.Thanks for the help.
|
|
|
Post by bobby167 on Mar 6, 2022 20:52:36 GMT -5
Sorry, just answering your question how to get fuel / oil tanks out.
|
|
|
Post by edju1958 on Mar 6, 2022 21:23:05 GMT -5
You don't have to apologize Bobby.Maybe I came off a little gruff on my reply.I did thank you for your help.You had no idea that I knew how to take the saw apart.You did the right thing.I didn't know how to get the tanks out,so you helped me out.
|
|
|
Post by edju1958 on Mar 15, 2022 21:04:16 GMT -5
I ordered the part (02495) & it's NOT the correct part.That's for a double trigger saw.The correct part # is 69872.
|
|