69dz302
Collector wannabe
Posts: 15
|
Post by 69dz302 on Mar 4, 2022 15:44:54 GMT -5
I have 2 360 parts saws..one runs one don't..one has a automatic oiler the one that don't run has a adjustable oiler can I swap out the oilers? Is there a difference?
|
|
|
Post by blythkd on Mar 4, 2022 20:32:35 GMT -5
Only way it can be done is by changing out the crankcase too. So that's a no. At least it's not feasible.
|
|
69dz302
Collector wannabe
Posts: 15
|
Parts saws
Mar 13, 2022 11:00:09 GMT -5
via mobile
Post by 69dz302 on Mar 13, 2022 11:00:09 GMT -5
Dug into the parts saw...intake boot was in two..put a new one in,rebuilt the carb and now it don't run? It ran before just wide open I am guessing from the bad boot...I have try,d a new plug changing the carb, checking spark everything seems ok? I did notice gas coming from the muffler when I was pulling it over...
|
|
|
Post by blythkd on Mar 13, 2022 20:04:53 GMT -5
Might check your carb metering diaphragm. It's the one held on with 4 screws. Many bargain carb kits nowadays have an improper diaphragm that causes flooding. The button in the middle of the aluminum disc is too tall. Do you still have your old one to compare to?
|
|
69dz302
Collector wannabe
Posts: 15
|
Parts saws
Mar 13, 2022 22:14:13 GMT -5
via mobile
Post by 69dz302 on Mar 13, 2022 22:14:13 GMT -5
I do not...it fell apart when I pulled it apart...with a ripped intake boot it would run with a hit of gas.. wide open but it ran...now nothing..
|
|