|
|
Post by muzzleblastm38 on Jan 3, 2021 15:07:00 GMT -5
|
|
|
|
Post by 5terrysupersaws on Jan 3, 2021 16:12:51 GMT -5
No, that cylinder will NOT fit the XL-76 . |
|
|
|
Post by kevinm1980 on Jan 3, 2021 16:24:49 GMT -5
Pistons are readily available, proline ones on eBay, little red barn has them, chainsaws, they use same piston as the super xl
|
|
|
|
Post by edju1958 on Jan 3, 2021 18:23:49 GMT -5
If the XL-76uses the same piston as the SXL,then go to Sawzilla.com & buy the Proline kit there.I've heard a lot of negative things about the piston kits from LRB.The Proline kits are $29.95 + $4.50 shipping.
|
|
|
|
Post by muzzleblastm38 on Jan 3, 2021 22:02:21 GMT -5
|
|
|
|
Post by undee70ss on Jan 3, 2021 22:18:06 GMT -5
|
|
|
|
Post by muzzleblastm38 on Jan 4, 2021 11:21:05 GMT -5
|
|
|
|
Post by undee70ss on Jan 4, 2021 18:19:29 GMT -5
None of the kits you posted, the cylinders will NOT fit a xl76. Do you need a piston and cylinder or just a piston? |
|
|
|
Post by muzzleblastm38 on Jan 4, 2021 18:37:41 GMT -5
cylinder also
|
|
|
|
Post by xl130 on Jan 4, 2021 21:24:32 GMT -5
This piston will work. www.ebay.ca/itm/222623864932 It’s aftermarket but I believe they are decent quality. The actual Homelite part number that you can search for is 68438. Cylinders for the XL-130 & 76 are hard to come by. A 64405/69723 will work. The original Homelite cylinder for my 76 & 130’s were all stamped 67124. If there are no gauges in the cylinder wall of you saw you can likely reuse it. A bit of polishing with very fine sandpaper or scotch brute pads will do a lot of good. Good luck! |
|
|
|
Post by muzzleblastm38 on Jan 10, 2021 15:45:23 GMT -5
Great news for me the cylinder is great shape
The only reason I wanted a cylinder kit is the piston add scoring
And new from this generation as soon you remove the
Piston for scoring the cylinder is junk and damaged
I suppose the chrome plating is better now
|
|
|
|
Post by muzzleblastm38 on Jan 12, 2021 15:45:20 GMT -5
for cylinder base gasket what is the tickness
|
|
|
|
Post by 5terrysupersaws on Jan 12, 2021 16:03:35 GMT -5
for cylinder base gasket what is the tickness Cylinder Base Gasket thickness = .015" - .016" ( 1/64" ) . |
|
