|
Post by Mr_Huns on Nov 13, 2020 15:10:07 GMT -5
Pardon me. I tried to look around for the answer, but only found an incomplete teardown guide. I inherited this Homelite 330. It came in a box of parts. I'm sure you can tell the story. The piston was scored and the rings were fubar. So I ordered a piston from "Little red barn" (big mistake) that was 0.002" to big to drop into the cylinder. After polishing it on the lathe to the correct dimensions; I have this little dilemma. TL;DR I'm stuck on the placement of this little spring in the trigger assembly. I understand the safety spring and the compression spring for the trigger lock, but what about the little extension spring; Where does it go? Sorry to be long winded. I would really appreciate some help from the guru's. Thanks, Huns P.S. I can't figure out how to add images from my phone. Attachments:
|
|
|
Post by Jarhead ☠ on Nov 13, 2020 21:23:18 GMT -5
Here you go!
|
|
|
Post by Mr_Huns on Nov 13, 2020 21:34:47 GMT -5
Dude!!
Thank you so much. I literally tried turning it around a few different ways, got frustrated, and gave up. I was like, "this end is bent weird. It had to be installed wrong."
I totally owe you big!
|
|
|
Post by Jarhead ☠ on Nov 13, 2020 22:16:29 GMT -5
You should have a 2nd spring around the throttle lock lever too, #11.
|
|
|
Post by Mr_Huns on Nov 14, 2020 13:52:01 GMT -5
Again, thank you so much!
I figured out how the other 2 springs installed. That throttle lock lever spring, the hook went around the exposed to operator portion of the lever.
I totally would not be able to get this together without your help. This site is awesome.
|
|
|
Post by Jarhead ☠ on Nov 14, 2020 17:10:31 GMT -5
We try!
|
|