|
Post by makowicki on Sept 22, 2020 14:56:15 GMT -5
a bad day yesterday, I was getting a few saws ready to cut up some large oak. My 923 that I have not used in years ran good for about 1 minute then just died. No spark, I swapped in one of the points replacement chips still no spark. Looks like a coil replacement i will have to order that.
Then my 410 started to run like crap, now it has spark but seems to just flood. Could be the carb or the intake boot. Ugh
|
|
|
Post by Jarhead ☠ on Sept 27, 2020 19:07:48 GMT -5
Did you check the spark plug wire?
|
|
|
Post by edju1958 on Sept 27, 2020 21:18:19 GMT -5
You might want to think about replacing the plug too.Also with a chip you might have to reverse the wires.
|
|