|
Post by tommyhnavix on May 20, 2018 13:06:17 GMT -5
|
|
|
Post by sweepleader on May 20, 2018 13:24:55 GMT -5
Leon, you need one of these to go with your grinder! Nevermind the manual one, POWER is the way to go. Get one and put a Homelite engine on it.
This is pretty similar to the presses spring shops use to curve leave springs to match specs for replacements on trucks. I have seen them use a vertical press with a short length of U channel to support the spring leaf while it is bent. Could do the same thing to straighten a bar, this one is made so you can see what you are doing, very clever.
|
|
|
Post by onlyhomelites on May 20, 2018 21:18:03 GMT -5
That would take some time to master, but it's very impressive!
|
|