Can anyone help identify these parts?

[dewaynep]

Hi everyone. I have finally come to the end of my Homelite parts inventory. I have just a handfull of parts left that had no part numbers associated with them. I am sure I have seen some of these parts before, but I can't seem to locate a part number for them. If anyone recognizes these parts can you please let me know what they are for? Thanks.


I have edited this to reflect only what I haven't had identified yet. The only caps left to identify are the 2 leftmost ones. The oil lines I would imagine are going to be the difficult ones. Thanks.





Thanks

[tribulation138]

i know the black oil cap 4th one over from the left is defiantly for the SXL and xl-12 series saws.

the blue pull start and red crank case side castings look to be all from the WIZ model saws.

If MCS was still alive he would know right off the bat.

[chainsawlady]

Maybe some of these figures might help.
air brush is for 26LCS- AA-77260
Black oil cap for early XL-2 oil tank with external threads Number of cap is A-70446-A
Black oil cap may be 63717A now UP06813 for several Homelite models.
The Fairbanks Morse starter assy is for the Homelite gear saws Wiz etc. A-56540-2 . All parts except the cover are the same for the direct saws Zip, 600 etc. also. The pin that holds the rope in is on opposite sides. If you check IPL for DD the rope comes up from the bottom. On gear saws IPL shows rope coming from the top to down. Hope you can understand what I am saying.
As for the drivecase it is probably for a Homelite from C-72 on up to Super 2100. They have several different part numbers. Is there a number on the casting? Sometimes they are right but mostly they are different as you have probably found out.
If I can come with another for the caps I will let you know. The bit red oil cap looks familiar and should be on an older saw, but I can't recognize it yet.
[e-mail]

[karla48]

The funny looking cast plate with the hole in the middle, looks like part # 94342-1, "Plate-Carb, chamber", I know it will fit my Homelite 330, but not sure how many other homelites used the same looking plate. Anyhow, the hole in the middle is for the round end of the air intake boot.

[dewaynep]

Thanks everyone for the quick replies. I've got some research to do now. Joyce, yes, there is a casting number on the drivecase, I'll check it out and post it up. Thanks again.