|
Post by Jarhead ☠ on Mar 21, 2023 15:09:00 GMT -5
Good afternoon group, I'm looking for the correct medium for a sandblaster to clean off the saw paint. I'm also looking for paint #'s for powder coating. Red, black, green and blue. I'm about to start my 1130G restore.
Thanks, Al
|
|
|
Post by ronaldt on Mar 21, 2023 22:07:54 GMT -5
Good afternoon group, I'm looking for the correct medium for a sandblaster to clean off the saw paint. I'm also looking for paint #'s for powder coating. Red, black, green and blue. I'm about to start my 1130G restore. Thanks, Al I have used glass beads in the past with good results.
|
|
|
Post by onlyhomelites on Mar 22, 2023 10:27:26 GMT -5
With my undersized 20 gallon compressor, the aluminum oxide from Harbor Freight works quite well.
|
|
|
Post by blackimaje on Apr 4, 2023 12:25:12 GMT -5
Just curios-what is the CFM's everyone is using for sandblasting parts -I tried with my little compressor but it's not doing much with only 2.4 CFM @90 PSI and 3.7 CFM @ 40 PSI-the required is at least 7 CFM's but hey -not everyone can afford a 1500-3000 dollar compressor. Also -has anyone used this ? CRC Evapo-Rust Gel Rust Remover, 8 Fl Oz, Rust Remover for Vertical Surfaces, Eliminates Oxides from Aluminum, Cast Iron, and Steel
|
|