|
Post by tangobravo on Aug 3, 2022 13:47:02 GMT -5
Yes, it is for a Mcculloch Mini Mac 35 saw, but I cannot figure out how the grinder/sharpener is supposed to go into the bracket and what the thin wire clip is supposed to do. I imagine some of you here might have some good advice/ sources to find an instruction sheet or something?? Any ideas on how this crazy thing assembles? I am trying to get one of these back together and am a bit lost on this!
|
|
|
Post by tangobravo on Aug 3, 2022 15:23:37 GMT -5
IPL shows NO retainer wire for use, and the 2 plastic parts just ratchet-screw together with a left has thread. The whole assembly drops thru the 2 notches of the retaining ring and turns about 30 degrees clockwise to hold it in. This wire must be for some other application use.
|
|
|
Post by w30bob on Aug 3, 2022 21:25:16 GMT -5
|
|
|
Post by tangobravo on Aug 3, 2022 21:43:51 GMT -5
Yeah-they seem to be listed as a "knob retainer bail" to somehow hold/retain the adjusting knob or something--- But my IPL for my early '77 Mini Mac 35AS shows no such part on the diagram. Seems to not be any information out there on how this all goes together. Confusing.
|
|
|
Post by int3414 on Apr 15, 2023 21:25:05 GMT -5
im doing the same thing,same saw....waiting on parts...why am i doing it...just for looks..ha
|
|