|
Post by westcoastthumpin on Sept 6, 2020 17:08:44 GMT -5
What do you guys use for pulling flywheels?
Also, what is the thread count on the flywheel nut for a SXLAO? Mine is buggered up. Is it a standard nut or do I need to order a new one?
|
|
|
Post by xl130 on Sept 6, 2020 17:38:22 GMT -5
This is the one I bought. I’ve used this puller on about 15 saws to date. It hasn’t failed me yet. I gave it a heck of a challenge yesterday. The worst flywheel I’ve ever pulled. I ended up bending the main plate but it still did the job. I would highly recommend it! www.ebay.ca/itm/352366548200The flywheel nut is a “jam nut” I believe. I think they are slightly thinner than a normal nut. Possibly a regular nut would would work though. Not sure about that. I have a box of 5/16-24 jam nuts that fit any Homelite I’ve encountered including a XL-12. Hope this helps!
|
|
|
Post by westcoastthumpin on Sept 6, 2020 19:50:15 GMT -5
Thank you. I will check out that puller.
I will see if I can source a nut locally.
|
|