|
Post by timinnb on Aug 27, 2020 15:22:46 GMT -5
I have a number of NOS/slightly used Homelite guide bars and was wondering if there is somewhere to look up early Homelite guide bar applications prior to 1976? Leon has a 1976 Product catalog that lists the bars for particular saws and the dealer service memo 671 from 09-76 lists the current universal bar part numbers but what about the earlier part numbers prior to the universal guide bars? The numbers on the guide bars I have are(the numbers are typed as they appear on the bar):
GW101250 - Red stencilling with Homelite Perma-Hard Tip on it GW12-50 - Blue stencilling with Homelite on it GW12501 T - Red stencilling with Homelite on it GW12-503AT - Red stencilling with Homelite Parma-Hard Tip on it GW12503AT - Red stencilling with Homelite Parma-Hard Tip on it GW 12503 AT - Red stencilling with Homelite Parma-Hard Tip on it GW-12503AT - Painted grey with just the red word Homelite on this one like the newer bars GW20-50 - Red stencilling with Homelite Parma-Hard Tip on it GW20503AT - Red stencilling with Homelite Parma-Hard Tip on it GW-24501-T- Blue stencilling with Homelite Parma-Hard Tip on it
One of the 12503 bars has four oil holes in it and the rest only have two.
I also have an Oregon Super-Tronic bar that is stamped 17869 and then under it is 2450B0205. Not sure what that one fits.
|
|
|
Post by onlyhomelites on Aug 29, 2020 10:16:58 GMT -5
I'm afraid I don't have any literature that summarizes these part#'s...I have some recorded in my database that were collected from the IPL's.
GW-101250: Super XL, XL-12
GW-12503-X: EZ,, EZ Automatic, EZ-250, Super EZ, XL-Mini, XL-Mini Automatic, XL-101, XL-102, XL-103, XL-104, XL-113, XL-114, XL-122, XL-123
If you can post pics of the other bar mounts, we can likely ID those easily enough.
|
|
|
Post by undee70ss on Aug 29, 2020 16:14:41 GMT -5
|
|
|
Post by onlyhomelites on Aug 30, 2020 22:17:15 GMT -5
Another reminder that I need to finish the Service Bulletin master list! I almost need to pull that list and post it in the cutting section...
|
|