|
Post by edju1958 on Aug 2, 2020 20:47:18 GMT -5
Hi folks,Yup,I found another Super2 that shouldn't take much to get going again (I hope,Lol).This is a later model saw with the special needle caps that don't allow you to adjust the carb more than 1/4 turn either way.I noticed that some dumb ass put oil in the fuel tank,so that got dumped out along with the water that was in it.I rinsed it out good & put new fuel in it hoping to have a runner,but that wasn't the case.It did run for a short time albeit erratic.Then I noticed a good sized puddle of fuel on the floor.Either the fuel line broke,or the fuel tank developed a leak.I'll save this saw for the winter as I already have about 3 or 4 Super2's that are runners.I've never had the opportunity to take one out cutting before,maybe this fall.
|
|