|
Post by edju1958 on Jun 19, 2020 16:04:42 GMT -5
I had this chainsaw given to me about 1 1/2 yrs.ago & never did anything with it till today.The UT # is 10799R & from what I could find it translates to a N3014? I dumped out the old fuel & put fresh fuel in it,hit the primer bulb a few times,pulled on the choke,& pulled it over.It fired right up & ran really well.After going through the saw I found that it needed a new spur sprocket & the chain adjuster screw & pin are gone.I ordered new ones from Leon & the new sprocket is coming from Ebay.I might have a potential buyer as I write this.I thought it might've been a cheapo Ryobi saw,but I saw on the tag that it was made in the N.C.plant.
|
|
|
Post by Waterloo on Jan 18, 2023 11:17:57 GMT -5
Yup just got one of theses, Will not start, Check plug, has spark, Filter really oily, plan to clean filter, everything else looks good.
|
|