|
Post by xl130 on May 15, 2020 12:05:26 GMT -5
I’ll have to take a better look again. The pressure gauge was an item that I purchased a few months back. It had an adapter that fit the threads but it extends way to far into the cylinder and will actually make contact with the top of the piston.
I’ll need an adapter with shorter set of threads.
|
|
|
Post by sweepleader on May 16, 2020 9:28:05 GMT -5
Short 14mm threads have been the norm in my experience. There might be a long adapter on there already, removing it might solve the issue.
|
|
|
Post by Jackmorgan on Mar 25, 2024 7:22:59 GMT -5
Interesting.....I put a NOS 64405 cylinder on this saw with the lil red barn SXL piston. What piston was in a XL-122? Maybe I would have been better off putting the cleaned up XL-130 jug back on.... For anyone reading this thread after searching for reviews, DO NOT BUY pistons from lil red barn. I orderd some oversized pistons for my kohler ch20 and one of the pistons was defective. Contacted lil red barn countless times and they're ghosting me. Terrible service and very disappointed. Go elsewhere!!!
|
|