|
Post by charles on Dec 31, 2019 9:04:01 GMT -5
I made this Vice Tool out of a scrap piece of 1&1/2"x 11ga. (1/8" wall) square tube . The bar stud holes can be drilled for one saw or slotted so it fits additional saws . Not as fancy as others I have seen here , but for the occasional user , it works . You can rotate the saw in 90* increments and move it around in the vice for different access points . Charles
|
|
|
Post by edju1958 on Dec 31, 2019 9:30:06 GMT -5
As the old saying goes....necessity is the mother of invention.I know you didn't exactly "invent" this tool,but you fabricated one out of raw materials which takes a considerable amount of thought. Ed
|
|
|
Post by sweepleader on Dec 31, 2019 12:09:27 GMT -5
The picture shows washers on the studs, that is a good thing as the threads on lots of saws are not long enough to tighten up on something as thin as the wall of that tube. Just mentioning it as others making something like this might not know and damage the studs or nuts without realizing.
Nice work, that would save a lot of trouble in working on a saw.
|
|