|
Post by edju1958 on Dec 11, 2019 23:25:48 GMT -5
Part # 63535-3T for an XL-902.The muffler body I have is solid,but the nuts that hold 2 of the shoulder screws are broken off the little dog ear flanges & the front flange is completely gone.I don't know if the 901,903,& 904 muffler body,part # 63535-1A will work. Ed
|
|
|
Post by oologahan on Dec 18, 2019 22:43:42 GMT -5
Part # 63535-3T for an XL-902.The muffler body I have is solid,but the nuts that hold 2 of the shoulder screws are broken off the little dog ear flanges & the front flange is completely gone.I don't know if the 901,903,& 904 muffler body,part # 63535-1A will work. Ed
A few months ago a guy had three complete chrome early 900 muffler sets, I bought them all for my older XL-900 saws. I also bought two complete chrome SXL chrome mufflers for the blue SXL's, but they were much higher than the 900 chrome mufflers. BTW I beleive the T on the end of the part number is a Terry part designation. The 902 you have is probably circa 1970-1973, so the 901-904 may work
|
|
|
Post by edju1958 on Dec 19, 2019 10:38:50 GMT -5
I should've probably updated this last week.Back about 2 yrs.ago I had (still have) a 902 with a 903 engine & a 925 rear handle & air box assembly.Back then I was going to try to repair it,but the cylinder & piston were scored,but before I found that out I'd ordered a new muffler body for it from Leon.I had the muffler body squirreled away & found it to use on the newest 902,so the saw is good to go in that respect. Ed
|
|