|
Post by 5terrysupersaws on Sept 15, 2019 15:21:26 GMT -5
the carb gasket on the left has the opening for the lo side, the one on the right just has the hole. but there are holes on both circuit plates for the lo side that makes me think the one on the right is correct, which it had originally. or is the circuit plate wrong
The circuit plate gasket on the right is the correct one, as the HDC-39 has independent circuits for the Hi - Lo side see the link below; www.walbro.com/wp-content/uploads/2016/01/HDCseries.pdf
|
|
|
Post by ladrigan on Sept 18, 2019 21:40:21 GMT -5
thanks for the confirmation! I had it running the other day for about a half hour. could not get it to idle properly. still had to give it throttle to keep it going. Ordered a manifold intake gasket. figured i would try that. ive got one of the hdc39a carbs in it. it pump fuel and runs, so the carb is ok. I've gotten good at tearing it down quickly!
|
|