|
Post by edju1958 on Nov 11, 2018 16:18:25 GMT -5
Hi Joyce,wondering if you'd have a 3/8 pitch clutch drum (part # A-97172,6T or Part # A-95458,7T) for a 245 with the race (part # 65746-B) & bearing (part # 68512).Used is OK.Thanks! Ed
|
|
|
Post by undee70ss on Nov 11, 2018 22:15:46 GMT -5
|
|
|
Post by edju1958 on Nov 11, 2018 22:55:00 GMT -5
Thanks Greg.You know,I've got some clutch drums here now that are just like that,but the hole on my 245 is much smaller than the one on Ebay & mine I have here. Ed
|
|
|
Post by edju1958 on Nov 12, 2018 16:27:16 GMT -5
Here is a pic of the two I have here now.The one on the left is the one that was on the saw when I got it.Ther one on the right is the one that I picked up on Ebay back in the spring.I tried to tap the race & bearing out with a drift pin,but it wouldn't move.
Ed
|
|
|
Post by chainsawlady on Nov 14, 2018 0:03:53 GMT -5
Have been having some computer problems and couldn't send messages. My one grandson helps me out of trouble and decided the keyboard locked up and I couldn't send messages. Finally got it going. Checked my 95458 sprocket and it looks like the right side you show on your picture. It only has the bearing with it, no race. It says it is the same size for a Super EZ. If you have a 3/8 " on an S-EZ, you could check it.If you have a race on your 245 it probably would fit. ??ut right now I think it is the same as your right side sprocket. joycewilson26@gmail.com
|
|
|
Post by onlyhomelites on Nov 14, 2018 9:45:18 GMT -5
Ed, the sprocket on the right requires a 64124 bearing and 65746-B bearing race...the same setup used on a Super XL & many other Homelite saws. Even if you can get the bearing out of the .325" sprocket on the left, it would not fit the 3/8" sprocket on the right.
|
|