|
Post by makowicki on Dec 27, 2017 17:28:11 GMT -5
I have rebuilt 2 of the SDC carbs with no issues at all. I have rebuilt 2 of the tillotson carbs, both have the same issue. They just flood out. The kits don't have the small welch plug so I don't touch that one. the kit is supposed to fit the carb. Stens 615-104, I have done two carbs both start ok then when I pull the throttle the saw floods gas end up in the air box. I tried leaning down the needles but is never runs correct. If I just about close the HI speed it will run up but not so good. Do I need to set the float/needle valve. the parts look just like the ones coming out.
|
|
|
Post by sweepleader on Dec 27, 2017 18:50:00 GMT -5
|
|