|
Post by kevinm1980 on Jan 26, 2022 8:04:14 GMT -5
Never bothered to measure one while apart but assuming these saws used the thick skirt design and any 2" skirt cylinder will fit, is this correct?
|
|
|
Post by charles on Jan 26, 2022 8:15:56 GMT -5
The wrist pin to the top of the piston measurement , along with the overall height would a determining factor .
Also , the wrist pin diameter would have to be the same , along with the weight of the assembly .
Charles
|
|
|
Post by kevinm1980 on Jan 26, 2022 13:24:50 GMT -5
The wrist pin to the top of the piston measurement , along with the overall height would a determining factor . Also , the wrist pin diameter would have to be the same , along with the weight of the assembly . Charles I'm referring to the cylinder skirt, not piston
|
|
|
Post by xl130 on Jan 26, 2022 18:47:59 GMT -5
Which cylinder did you have in mind?
|
|
|
Post by kevinm1980 on Jan 26, 2022 21:35:41 GMT -5
Which cylinder did you have in mind? Looking at 64405,but actually took apart a vi130 to salvage for parts and that is set up for a 2" skirt so the 64405 will work
|
|