|
Post by bigdaddy on Dec 14, 2021 14:07:35 GMT -5
Hey guys does anyone have a thread or video of how to fix the governed carb I blocked off the governor but what can I do about the jet ….I seen chainsaw mans video of replacing it but where can I get it or can I block it somehow …thanks guys ..
|
|
|
Post by kevinm1980 on Dec 14, 2021 15:46:16 GMT -5
Been wondering the same thing and might try. To block the hole going to the metering chamber
|
|
|
Post by xl130 on Dec 14, 2021 18:59:07 GMT -5
Here are two videos that I cover how to disable the governed Tillotson carburetors and replace the drilled nozzle. I used jb weld to cover the hole in the nozzle on another saw. Not sure how resistant to fuel and ethanol that stuff is though. I think it would last but not sure. youtu.be/kIQOPDpORigyoutu.be/7mzwDikb8_g
|
|
|
Post by bigdaddy on Dec 15, 2021 2:06:15 GMT -5
I blocked the govenor but not the drilled jet and now it acts like it has an air leak it won’t idle and you can’t tune it in so I guess I need to try and block the drilled jet….thank you guys for your help I’ll let you know how it goes
|
|
|
Post by xl130 on Dec 15, 2021 5:08:19 GMT -5
I guess I misinterpreted your questions. Did the saw run good before you blocked off the governor?
|
|