|
Post by nickr on Apr 10, 2021 2:00:18 GMT -5
Good day all! I have the above 2 stroke brush cutter which will no longer start. I was using it and it worked fine tho' it did cough from time to time, so I cleaned the air filter when i stopped to refuel. Machine then refused to start. I have since changed the spark plug, checked continuity in the kill switch and the leads to the coil. There is fuel in the primer bulb and I can smell fuel in the cylinder when I pull the starter cord with the spark plug out. I do not seem to be able to see a spark when I turn the engine over whilst shorting the spark plug out on the engine body. Is the problem the HT lead? All suggestions welcome, thanks in advance
|
|
|
Post by undee70ss on Apr 10, 2021 16:25:25 GMT -5
Probably needs a new module.
|
|
|
Post by nickr on Apr 21, 2021 8:27:11 GMT -5
Thanks for the speedy reply - been a bit busy recently and only just checked! Is there another name for " the module " because that doesnt feature in my parts list!!! Thanks again
|
|
|
Post by undee70ss on Apr 21, 2021 11:17:31 GMT -5
Thanks for the speedy reply - been a bit busy recently and only just checked! Is there another name for " the module " because that doesnt feature in my parts list!!! Thanks again Would need more information. Does your brushcutter have a points ignition? What color is the coil?
|
|
|
Post by nickr on Apr 23, 2021 10:48:08 GMT -5
good morning Is this what you meant? Have a good one
|
|
|
Post by undee70ss on Apr 23, 2021 23:48:29 GMT -5
Yes. AS a test disconnect the small wire from the module to the kill switch and check for spark again.
|
|
|
Post by nickr on Apr 26, 2021 9:47:59 GMT -5
Good morning Still no spark - so the solution is a new "module" right? Thanks vm
|
|
|
Post by undee70ss on Apr 26, 2021 13:42:59 GMT -5
Good morning Still no spark - so the solution is a new "module" right? Thanks vm Imo yes.
|
|
|
Post by nickr on Apr 27, 2021 2:34:51 GMT -5
I will let you know how it goes!!!
|
|