Post by hotajax on Oct 12, 2014 10:55:13 GMT -5
Got a new duckbill. Removed the brass cone-shaped filter from the hole in the cap. Took out the old duckbill. Stuck a paperclip in the hole and removed all the crap that was in the hole. Put in a new duckbill. Replaced the brass filter. Ran the saw, and it got starved for fuel. Took out the duckbill, cut a small hole in, and tried to run it. This time ran, but gas leaked out. My question: I know it seems like a very simple task, but what is proper? Thanks, gents. J